Siemens SINAMICS V20 VFD
Siemens SINAMICS V20 VFD code F63: Parameter cloning contents incompatible
The cloning file exists but is the wrong converter type, preventing the drive from loading the parameters.
- Code
- F63
- Name
- Parameter cloning contents incompatible
- Controller
- Siemens SINAMICS V20 VFD
- Type
- Setup or parameter fault
- What it does
- Fault: the equipment trips and stops
- Risk
- YELLOW Booth plays by its own rules
- Reset
- Needs a manual reset
- Source
- The manufacturer's manual (subscribers see which manual and page)
Updated November 4, 2026
How to fix it
Subscribers get:
- What to do next, in plain words
- What the manual says to do, and the page it is on
- The 1 common cause listed for this code
- Booking a live video call with Ben, a master booth technician ($250/hr, paid per call)
Questions about this code
What does Siemens SINAMICS V20 VFD code F63 mean?
The cloning file exists but is the wrong converter type, preventing the drive from loading the parameters.
Is Siemens SINAMICS V20 VFD code F63 dangerous?
It is graded yellow: not hard, but a booth does it differently than the gear most techs know, so follow the checks in order.
How do I fix Siemens SINAMICS V20 VFD code F63?
The manual's fix and the step by step check for this code are in WERCS Diagnose, plans from $49 a month. For help right now, WERCS answers 24/7 at (877) 489-3727.
Other Siemens SINAMICS V20 VFD codes
F52 · Converter software faultF60 · Asic timeoutF61 · SD card parameter cloning failedF62 · Parameter cloning contents invalidF64 · Converter attempted to do an automatic cF70 · I/O Extension Module communication faultF71 · USS setpoint fault (on RS232)F72 · USS/MODBUS setpoint fault (on RS485)F80 · Signal lost on analog inputF85 · External fault